Friday, October 18, 2013

Progress on Model

Here is the main design so far. I would like to make the handles hollow with holes in them to lighten the weight of it though. This is if we have buttons. I placed them toward the right side so you can easily push at least the one on the very edge while holding onto the handle.
The bottom will have a lexan window where you align the scan bed. 
Inside there is an adjustable plate that will tighten down on the back of the scanner. 


Sliding wedges can be tightened down into place to hold the scanner centered on the window. 

All the electronics will fit neatly into the lid. 

No comments:

Post a Comment